Proxim ORiNOCO AP-8000 User Manual page 131

Using CLI to Manage the Access Point
Configuring the Device Using CLI Commands
row-status: notInService
}
index 4 {
protocol-name: SNMP service
port-number: 161
port-type: both
interface: allInterfaces
row-status: notInService
}
index 5 {
protocol-name: IPSEC/ISAKMP
port-number: 500
port-type: both
interface: allInterfaces
row-status: notInService
}
index 6 {
protocol-name: L2TP
port-number: 1701
port-type: both
interface: allInterfaces
row-status: notInService
}
index 7 {
protocol-name: PPTP
port-number: 1723
port-type: both
interface: allInterfaces
row-status: notInService
}
Ethernet Configuration
Device-Name# show configure interface ethernet
// RUNNING-CONFIGURATION //
// Ethernet Interface //
ethernet
mac-address: 00:20:a6:b0:aa:a1
speed: oneGBit
transmit-mode: fullDuplex
}
Vlan Configuration
VLANs are very useful to segment the LAN into different broadcast domains. This helps in reducing the broadcast
domain by separating logical segments of a LAN. VLANs can operate in different modes based on the incoming traffic.
Perform the following commands to configure the VLAN parameters.
# configure
(config)# dev-configure
(config-dev<config>)# vlan
(config-dev<config>-vlan)# status enable
(config-dev<config>-vlan)# vlan-id -1
Device-Name# show configure vlan
// RUNNING-CONFIGURATION //
// VLAN Configuration //
{
AP-8000 User Guide
131