Using Web Interface to Manage the Access Point
Configuring the Device
•
Click Ok.
NOTE: Follow the above mentioned steps to configure the 11n Properties feature for Interface 2.
Ethernet
Perform the following procedure to configure the Ethernet Port:
1. Navigate to Configuration > Ethernet.
Figure 6-8 Ethernet Page
•
MAC Address: Defaults to the MAC ID of the device.
•
Speed: You can set the speed either One Gigabit, 10 Mbps, 100Mbps or Auto.
•
Transmit Mode: You can set the Transmit mode either to half Duplex, Full Duplex or Auto.
Security
Wireless Security
1. Navigate to Configuration > Security > Wireless Security.
Figure 6-9 Wireless Security Page
2. Click Add in the Wireless Security CFG table to create a new entry. The Wireless Security Create Row page
displays.
AP-8000 User Guide
63