Ip Configuration - Proxim ORiNOCO AP-8000 User Manual

Using Web Interface to Manage the Access Point
Configuring the Device
5. Select the QoS Marking Status.
6. Select the Entry Status for QoS table. This represents the entry status for the corresponding row in the table.
NOTE: If you want to customize a particular Policy Type, then the Entry Status for that Policy Type should be
Enabled.
7. Click OK.

IP Configuration

The Network IP Config is used to configure the internet (TCP/IP) settings for the Access Point.
These settings can be either entered manually static IP address, subnet mask, and gateway IP address or obtained
automatically (dynamic).
Network IP Config
You can configure and view the following parameters within the Network IP Config page:
NOTE: You must reboot AP in order for any changes to the IP parameters to take effect.
1. Navigate to Configuration > Network > Network IP Config. The Network IP Configuration page displays.
Configure the following parameters:
Figure 6-24 Network IP Config
• Address Type: Select the Address Type Static or Dynamic from the drop-down list.
– If you select the Address Type as Static, then you need to configure the following parameters and click OK:
— IP Address
— Subnet Mask
— Gateway IP Address
– If you select the Address Type as Dynamic, then the following parameters will remain as read only:
— IP Address
— Subnet Mask
— Gateway IP Address
AP-8000 User Guide
72