Proxim ORiNOCO AP-8000 User Manual page 67

Using Web Interface to Manage the Access Point
Configuring the Device
• Profile Name: Enter the profile name. This profile name is mapped to a VAP.
• Max ReTransmissions: Enter the Retransmission value.
• Message Response Time: Enter the Message Response time.
• Re Authentication Period: Enter the Re Authentication Period.
• Entry Status: Select the entry status for the profile.
Configure the following parameters for the radius servers:
• Server Type: This is read only parameter and it displays the server type.
• IP Address: Enter the server's IP address.
• Server Port: Enter the port number which the AP and the server will use to communicate. By default, RADIUS
Authentication/Accounting servers communicate on ports 1812/1813.
• Shared Secret: Enter the password shared by the RADIUS server and the AP. The default password is "public."
• Status: Select Enable from the drop-down box to enable RADIUS server, if required.
3. Click OK.
MAC Access Control
MAC Access Control page allows you to build a list of authorized wireless stations that can register at the unit and access
the network. MAC Authentication is supported on the wireless interface and only wireless MAC addresses should be
entered in the list.
1. Click Configuration > Security > MAC Access Control.
2. Select the Operation Type.
NOTE: Based on the Operation type, you can allow/deny the association of the MAC ACL profile to an SSID.
3. Click OK.
Figure 6-16 MAC Access Control Page
4. To add entries, click Add, the MAC ACL Add Row page is displayed.
AP-8000 User Guide
67