Proxim ORiNOCO AP-8000 User Manual page 74

Using Web Interface to Manage the Access Point
Configuring the Device
• Advanced Filtering
• TCP/UDP Port Filtering
Intra BSS Filtering
Using the Filtering parameters available in the Filtering page, you can configure the Intra BSS Filtering Status:
1. Navigate to Configuration > Filtering.
Figure 6-26 Intra BSS Filtering Page
2. Select the status of the Global Filter Flag from the drop-down box. You need to Enable the Status for Filtering.
WARNING: If you Disable the Status for Filtering, then the configuration for Filtering parameter will not be applicable.
3. Select the Intra BSS Filtering. The Intra BSS Filtering parameter controls the wireless to wireless communication.
• If set to Enable, then there will be no wireless to wireless communication.
• If set to Disable, then wireless to wireless communication is possible.
4. Click OK.
Protocol Filtering
Follow these steps to configure the Protocol Filtering.
1. Navigate to Configuration > Filtering > Protocol Filter.
2. In the Protocol Filter page, configure the following fields:
• Filtering Control: Select the interface or interfaces that will implement the filter from the Filtering Control
drop-down list:
— Ethernet: Packets are examined at the Ethernet interface.
— Wireless: Packets are examined at the Wireless interface.
— All interfaces: Packets are examined at both interfaces.
— Disabled: The filter is not used.
• Filtering Type: By default the Filtering type is set to Passthru. If you want to, then select the Filtering Type as
Block.
— In the Filtering Table, if the Entry Status of a particular entry is Enable, and the device will verify the Filter
Status of the particular entry and then perform the filtering process.
– If the Filter Status is Enable, then the packets will be allowed to pass through.
– If the Filter Status is Block, then the packets will be blocked.
AP-8000 User Guide
74