Alarm Host Table - Proxim AP-4000 User Manual

Performing Advanced Configuration
Alarms
• Image Trap Group
Trap Name
Zero Size Image
Invalid Image
Image Too Large
Incompatible Image
Invalid Image Digital Signature
In addition, the AP supports these standard traps, which are always enabled:
• RFC 1215-Trap
Trap Name
coldStart
linkUp
linkDown
• Bridge MIB (RFC 1493) Alarms
Trap Name
newRoot
topologyChange
All these alarm groups correspond to System Alarms that are displayed in the
AP to the SNMP managers specified in the

Alarm Host Table

To add an entry and enable the AP to send SNMP trap messages to a Trap Host, click Add, and then specify the IP Address and Password
for the Trap Host.
NOTE
Up to 10 entries are possible in the Alarm Host table.
• IP Address: Enter the Trap Host IP Address.
• Password: Enter the password in the Password field and the Confirm field.
• Comment: Enter an optional comment, such as the alarm (trap) host station name.
To edit or delete an entry, click Edit. Edit the information, or select Enable, Disable, or Delete from the Status drop-down menu.
oriTrapZeroSizeImage
oriTrapInvalidImage
oriTrapImageTooLarge
oriTrapIncompatibleImage
oriTrapInvalidImageDigitalSignature
The AP has been turned on or rebooted.
The AP's Ethernet interface link is up (working).
The AP's Ethernet interface link is down (not working).
Description
This trap indicates that the AP has become the new root in the Spanning Tree
network.
This trap is sent by the AP when any of its configured ports transitions from the
Learning state to the Forwarding state, or from the Forwarding state to the
Blocking state.
This trap is not sent if a newRoot trap is sent for the same transition.
Alarm Host Table.
Description
Description
System Status
AP-4000 User Guide
Severity Level
Major
Major
Major
Major
Major
Severity Level
Informational
Informational
Informational
Severity Level
Informational
Informational
Screen, including the traps that are sent by the
71