Capping Station Maintenance; Figure 5-5 Debris On The Media Driver Roller; Figure 5-6 Capping Station - Oce Arizona 500 User Manual

Océ | Printer Maintenance
• Media drive roller - follow the general cleaning procedure (see "General
Cleaning" on page 5-5) with emphasis on the debris that accumulates on the
center of the roller (see Figure 5-5).

Capping Station Maintenance

5.5
The capping station (see Figure 5-6) consists of a single plate with 24 small saturated foam
pads (OIN #3011924173). The station is used to cap and preserve the print-head nozzles
when the printer is idle between images. The cleaning solution/fluid is pumped up to the
plate to provide continuous saturation to the pads to prevent the solvent ink from drying
on the nozzles.
The capping station has funnel-shaped sections with drain holes for each of the print heads.
During daily printing operations, purges ensure nozzle integrity before and during prints.
The ink is sucked away through a manifold and into a single tube down to the waste bottle.
Over time, the bottle fills and must be emptied. Notification is via the control panel.
5-8

Figure 5-5 Debris on the Media Driver Roller

Figure 5-6 Capping Station