Table of Contents
Advertisement
Océ | Control Panel
2.
Press the ACCEPT button. You then see:
OPERATOR
print parameters
3.
Press the MENU button four times. You then see:
OPERATOR
media menu
4.
Press ACCEPT. You then see:
MEDIA MENU
Media table version: XXX
The media table contains the printer set-up values that are implemented when a
media is selected through the Media Type submenu. The version is updated by a
separate file that typically accompanies a new firmware version.
5.
Press ACCEPT. You then see:
MEDIA MENU
print side: first side
If you select the first side, go to step 9.
6.
Use the +/- buttons to select the second side. You then see:
MEDIA MENU
print side: second side
7.
Press ACCEPT. You then see:
SECOND SIDE
supply core OD: (3.10" - 4.0")
Use the +/- buttons to enter the correct core diameter. The value is increased or
decreased in .01-inch increments. If you do not know the diameter, use a ruler and
measure the outside diameter of the core, and enter the value in this submenu.
8.
Press ACCEPT. You then see:
SECOND SIDE
condition media: OFF
Use the +/- buttons to turn media conditioning OFF/ON. The default value is
OFF.
Condition Media assists in accurate two-sided printing where the printed media
surface tension of the first side affects the printing of the second side. When set
ON, the printer advances the media the length of the print and rewinds to the
starting point.
For additional information, see "Firmware 2.2 Notes" on page C-12.
4-22
Advertisement
Table of Contents
