Table of Contents
Advertisement
Print & Go Media Installation
6.
From the front of the printer, push/pull the media towards the drive roller, making sure
it passes between the drying duct and the drive roller (see Figure 3-9). Use the +/-
buttons to add more or less media during installation.
7.
Route the media under the dancer arm, around the bottom of the rubber feed roller,
and out over the top of the pinch roller assembly by lifting the metal roller
(see Figure 3-14). Before proceeding to step 8, walk behind the machine and verify
that the left edge of the media is straight and that no coning or sliding has occurred.
The left edge of the supply media roll should be straight.
Figure 3-14 Media Routing
7/26/04
3-17
Advertisement
Table of Contents
