Emtu Take-Up Roll Reattachment - Oce Arizona 500 User Manual

Océ | Media System
The feed adjustment feature enables the adjustment of media stepping to
compensate for variation in media lots and environmental factors. The plus
direction lengthens each media step. The minus direction shortens each media step.
For additional information, see "Firmware 2.2 Notes" on page C-121.
9. Press ACCEPT. You then see:
WRITING GAP
"Other" head gap: optimal/wide
Use the +/- buttons to set optimal or wide. The default is optimal. This option is
only selectable during the Load Media process.
The writing gap wide feature sets the print carriage at its maximum height to
accommodate media that may have surface wrinkles. They can lead to carriage
strikes, which may result in a ruined print and/or potential print-head damage.
For additional information, see "Firmware 2.2 Notes" on page C-12.
10. Press ACCEPT. You then see:
Sizing media
please wait
The printer sizes the media. If an error occurs, check the alignments along the
media path from the supply to the take-up core.
If no error occurs, you then see:
MEDIA MENU
media delivery mode: roll to roll or Print & Go
Use the +/- buttons to select Print & Go.
11. Press ACCEPT. You then see:
Stabilizing media
please wait
When stabilizing is complete, printer status information is displayed.

EMTU Take-up Roll Reattachment

3.4.3
Follow these steps to remove a full/partial take-up roll and reattach media to a new empty
take-up core:
1. Press the ADVANCE MEDIA button once, and press the + button until at least one
foot of media is exposed through the paper-feed access door after the media is cut.
2. Press the CANCEL button to ensure the media does not rewind at step 4.
3. Cut the media so that at least one foot of media is exposed through the paper-feed
access door, and remove the full/partial take-up roll.
3-26