Table of Contents
Advertisement
Océ
Precautionary Messages
0.2
Important: Powering off the printer is NOT recommended.
•
However, if the printer must be powered off for more than one hour and up to
one day, you must drain out all the ink from the ink reservoirs (juice boxes),
clean the print head nozzle plates, and cover the capping station with
polyethylene plastic film. If the printer must be powered off for more than one
day a trained service technician must flush out the printer ink system with
maintenance fluid, clean the print head nozzle plates, and cover the capping
station with polyethylene plastic film.
Warning:
If the printer is powered off, all ink will leak out of the ink reservoirs
within an hour or two unless you drain out all the ink.
General Recommendations for the Operator
0.2.1
•
Always perform the low or high purge using the Operator/Maintenance menu
as a first step to bring nozzles back for printing.
Warning:
Media must be installed prior to performing this function.
•
Prepare materials for each cleaning procedure before accessing the carriage
over the maintenance (blotting cloth) station.
•
Swab each print head nozzle plate after every four hours of printing and at the
beginning and end of each work day.
•
Manually flush print heads as a last resort to clear blocked nozzles. Contact
your field service representative for assistance with this procedure.
•
Read guidelines as outlined in the Material Safety Data Sheet (MSDS) before
handling or discarding ink contaminated items.
Cleaning the Capping Station
0.2.2
1.
Move the carriage assembly by using the Operator/Maintenance/Access Carriage
menu on the control panel. Open the entire right end cap assembly and locate the
capping station.
B-2
Advertisement
Table of Contents
