Table of Contents
Advertisement
5.
Press ACCEPT. You then see:
SCSI PORT
ultra SCSI: (on or off)
This parameter pertains to the SCSI card being used on the host PC. This
parameter should be set to On so that the host PC and the printer can negotiate the
highest transfer speed. If the cable is too long causing transfer problems, this
parameter should be set to Off. Use the +/- buttons to select On or Off.
6.
Press ACCEPT. You then see:
SCSI PORT
Interface cable detected: LVD or SE
7.
Press ACCEPT. You then see:
CONFIGURE I/O
active: SCSI
7/26/04
Configure I/0
4-33
Advertisement
Table of Contents
