Oce Arizona 500 User Manual page 144

Océ
U. At the end of the print, place a small flag at the
edge of the print. Make sure it extends out from
the side of the media and is secure. This will
identify the beginning of the second side of the
print. - see Figure C.
V. When all "Side One" jobs are completed,
advance approximately 10 feet of media prior to
cutting the substrate. This will allow for an
ample leader to leader to load the media on the
second side and area to perform maintenance, if
necessary.
Note: Be aware of the Space Between Print setting as this will affect how much leeway
you have to line up prints on the second side.
Note: Providing a minimum of 1 inch bleed on each side will help ensure usability of
both sides of the output.
Step 3: Preparing for two-sided printing
W. Remove the roll of printed media from the front of the printer and use it as the "new"
supply roll.
X. Select Load Media from the Océ Arizona 500 control panel.
Y. When prompted, specify Second-Side in the control panel, and complete loading the
substrate.
Z. Send the job to be printed to the Océ Arizona 500.
AA. Prior beginning the second side of the print job, the Océ Arizona 500 control panel will
prompt you to adjust the second side media into position.
BB. Press Accept and using the
with the mark on the platen from step #1 J above. Remove the flag from side 1. When done
press Accept and the printer will begin the printing process for the second side of the print.
- see Figures D and E.
C-6
Figure C
+\-
keys, align the Print Point mark you made on the media