Figure 5-1 Cleaning The Media Drive Roller; Figure 5-2 Take-Up And Supply Dancer Bar And Nylon Support Bearing - Oce Arizona 500 User Manual

Océ | Printer Maintenance
Weekly, the media drive roller should be wiped clean with a sponge/scrubber and 91% or
higher isopropyl alcohol only to remove any accumulated paper dust or residue.
Additional Debris Removal
If too much media debris accumulates on the components, it can track back onto the media
and ruin prints. To keep your prints clean and free of debris, routine cleaning should be
done after each media roll change. This is especially important when using medias with
adhesive backing. They have a coated layer that comes off easily and accumulates on various
areas of the printer.
Manually clean the following areas:
• Take-up and supply dancer and nylon support bearing - use a lint-free cloth
with alcohol to clean debris off the entire dancer bar, especially where it
contacts the nylon support bearing. Gently push back on the white support
and insert the alcohol-saturated cloth to clean the white support surface (see
Figure 5-2).

Figure 5-2 Take-up and Supply Dancer Bar and Nylon Support Bearing

5-6

Figure 5-1 Cleaning the Media Drive Roller

Nylon
Support
Bearing