Table of Contents
Advertisement
G. Observe the 4 marks made by the BLACK heads in the rear right hand corner -
see Figure A.
H. Using the second BLACK mark from the rear of the printer as a guide, and using a
straight edge to ensure accuracy, create a line continuing to the right side of the platen - see
Figure A.
I. Using masking tape, affix a piece of tape along this straight line - see Figure A.
J. Measure 5 mm
from the front edge
of the tape for 8-pass
printing and draw a
straight line to the
edge of the platen. -
see figure B.
K. Measure 10 mm
from the front edge
of the tape for 4-pass
printing and draw a
straight line to the
edge of the platen. -
see figure B.
L. These lines
accurately reflects
where your Océ
Arizona 500 begins
Figure B
printing in 8- and
4-pass modes, and will be used to line up the image on the reverse side.
Step 2: Printing the first side of your graphic
M. From the control panel, select Menu >>> Operator >>> Print Parameters >>>
Statistics and turn "Statistics" off.
N. In Onyx Rip Queue, highlight the Océ Arizona 500 and select Change.
O. From the Change Media and Placement window select Setup.
P. From the Placement Strategy window, set the Top and Left offsets to 0.00 and set
Justification to Right.
Q. Open the file to be printed in Pre-Flight.
R. Under Preview & Size tab, ensure the X and Y origins are set for 0 (zero).
S. In the Print menu, Print Setup window, select the Marks tab and check to see that Print
Label is not enabled.
T. Print the selected job(s). Be sure it is aligned to the right.
7/26/04
C-5
Advertisement
Table of Contents
