Table of Contents
Advertisement
Océ | Error Messages and Troubleshooting
CONTROL PANEL MESSAGE
WARNING
no media
WARNING
take-up roll full
Close All Doors and
press ACCEPT button
Waste Bottle Almost Full
Press ACCEPT to Continue
Please Replace Waste Bottle
and press ACCEPT button
Media Encoder error
press ACCEPT button
BLOTTING CLOTH IS ALMOST OUT
press ACCEPT to continue
BLOTTING CLOTH IS OUT
press ACCEPT to continue
Status and Low Ink Messages IR/PZ
XX:XX Media: XXX' Used: YY' IR/PZ:
Idle
XX:XX Media: XXX' Used: YY' IR/PZ:
DOOR OPEN
XX:XX Media: XXX' Used: YY IR/PZ:
CANCELLING PRINT
6-4
EXPLANATION AND ACTION
If no media is loaded, reload the media. If
media is loaded, perform the media installa-
tion procedure again.
The take-up roll has reached maximum
diameter. Remove the roll, and install a new
empty core.
Door is open. Close all doors, and press the
ACCEPT button.
Ink waste container is almost full. Monitor
closely, and replace or empty the ink waste
container. Then, press ACCEPT.
Ink waste container is full. Replace or empty
the ink waste container, and press ACCEPT.
The media is not contacting the media
encoder wheel properly. Perform the follow-
ing steps before you press ACCEPT:
1. Lower the media-encoder pinch roller.
2. Verify the supply and take-up core
notches are engaged into the mandrel hubs.
3. Verify that the media is not too thick or
stiff.
Check the amount of blotting cloth available
and monitor frequently. Replace the blotting
cloth before the next long print job.
Replace the blotting cloth, then press
ACCEPT.
Printer is idle. Printer feedback and status
for the operator.
Printer is idle, but the door is open. Close
the door to return to idle.
Printer is cancelling print. Provides printer
feedback and status for the operator.
Advertisement
Table of Contents
