Table of Contents
Advertisement
Océ | Control Panel
3.
Press ACCEPT. You then see:
Inks to High Purge
number of purges: (1-10)
Press +/- to select the number of purges to be performed (no more than two are
recommended).
4.
Press ACCEPT. You then see:
Inks to High Purge
B C LC M LM Y
Use the +/- buttons to select the required color or colors to high purge.
5.
Press ACCEPT to begin purging. The Cleaning Nozzles please wait and Printing
Nozzles Test please wait messages are displayed during the purge process.
Low Purge Nozzles
Warning:
Media must be installed prior to performing this function.
A low purge is the same as a high purge, except a lower pressure is used. No multi-purge
capability is available with the low purge. A blot at the maintenance station is performed
after the purge to clean the nozzle plate. If the printer is idle, a nozzle print follows the blot.
Follow these steps to perform a low purge:
1.
Navigate back to:
MAINTENANCE
high purge nozzles
2.
Press the MENU button. You then see:
MAINTENANCE
low purge nozzles
3.
Press the ACCEPT button. You then see:
INKS TO LOW PURGE
B C M Y LC LM
Use the +/- buttons to select the required color or colors to low purge.
4.
Press ACCEPT to begin purging. The Cleaning Nozzles please wait and Printing
Nozzles Test please wait messages are displayed during the purge process.
4-16
Advertisement
Table of Contents
