Table of Contents
Advertisement
Océ | Media System
6.
Install an empty take-up core/mandrel, and secure the hubs.
7.
From the front of the printer, push/pull the media towards the drive roller, making sure
it passes between the drying duct and the drive roller (see Figure 3-9). Use the +/-
buttons to add more or less media during installation.
8.
Work the media over the front dancer and around the back of the take-up roller (see
Figure 3-10). Before proceeding to step 9, walk behind the machine and verify that
the left edge of the media is straight and that no coning or sliding has occurred. The
left edge of the roll should be straight.
Figure 3-10 Wrap Around the Take-up Core
3-8
Figure 3-9 Feeding Media Over the Drive Roll
Advertisement
Table of Contents
