Table of Contents
Advertisement
Print Menu Tree
The Print Menu Tree menu prints the entire menu tree structure. Follow these steps to print
the menu tree:
1.
Navigate to:
TEST PRINTS
nozzle print
2.
Press the MENU button three times. You then see:
TEST PRINTS
print menu tree
The menu tree contains many fine vertical lines. Océ recommends setting the spit
stripe to DUAL to ensure optimal print quality (see page 4-7).
3.
Press ACCEPT. The Menu Tree begins printing.
Maintenance
0.4.3
The Maintenance menu (see "Maintenance Menu (Part 1)" on page A-5) contains several
daily-maintenance submenus required for printing quality images consistently. These
maintenance items should be performed often before and after printing. These procedures
are in addition to the automated maintenance that occurs without direct operator
intervention. Refer to the "Operator Maintenance Schedule Guidelines" on page 5-2 for
additional information and routine maintenance required on the Arizona 500 printer.
Several maintenance functions can be selected from the front panel menus when the
machine is idle or while printing. The maintenance duration parameters (spit times and
purge times) are set in the front panel menus. The waste pump is turned On during a spit
or purge and is left On for five seconds after the maintenance cycle is complete.
Warning:
Media must be installed prior to performing these functions.
For purge functions, a list of colors to be purged is presented for selection, for example:
INKS TO LOW PURGE
B C LC M LM Y
With this initial setting, all six colors are designated to be purged.
The underscore indicates the color that is the current active item of the list of colors.
Pressing + moves the underscore to the right. Pressing - replaces the letter with a bar. For
example, when B is underscored, pressing - changes the list to:
7/26/04
Operator
4-13
Advertisement
Table of Contents
