Table of Contents
Advertisement
When set to OFF, the printer does not rewind the substrate before printing. This
setting should be used for media that is very thin or adhesive backed, which may
wrinkle during rewinding or become malformed by the heat required to dry the
inks.
For additional information, see "Firmware 2.2 Notes" on page C-12.
8.
Press ACCEPT. You then see:
MEDIA MENU
feed adjustment: +/- 0 - 10
Use the +/- buttons to set the feed adjustment from -10 to +10. The default value
is 0.
The feed adjustment feature enables the adjustment of media stepping to
compensate for variation in media lots and environmental factors. The plus
direction lengthens each media step. The minus direction shortens each media step.
For additional information, see "Firmware 2.2 Notes" on page C-12.
9.
Press ACCEPT. You then see:
WRITING GAP
"Other" head gap: optimal/wide
Use the +/- buttons to set optimal or wide. The default is optimal. This option is
only selectable during the Load Media process.
The writing gap wide feature sets the print carriage at its maximum height to
accommodate media that may have surface wrinkles. They can lead to carriage
strikes, which may result in a ruined print and/or potential print-head damage.
For additional information, see "Firmware 2.2 Notes" on page C-12.
10.
Press ACCEPT. You then see:
Sizing media
please wait
The printer sizes the media. If an error occurs, check the alignments along the
media path from the supply to the take-up core.
If no error occurs, you then see:
Stabilizing media
please wait
When stabilizing is complete, printer status information is displayed.
7/26/04
Roll-to-Roll Media Installation
3-13
Advertisement
Table of Contents
