Oce Arizona 500 User Manual page 38

Océ | Media System
2. Press the ACCEPT button. You then see:
MEDIA MENU
thickness: (2.00 - 30.00) mil
The range for thickness values is 2.00-30.00 mils. The media thickness is typically
on the media container label, if any. The media thickness changes by .05 mils.
Use the +/- buttons to increment or decrement the thickness setting.
3. Press ACCEPT. You then see:
MEDIA MENU
takeup core OD: (3.10" - 4.00")
Use the +/- buttons to enter the correct core diameter. The value is increased or
decreased in .01-inch increments. If you do not know the diameter, use a ruler and
measure the outside diameter of the core, and enter the value in this submenu.
4. Press ACCEPT. You then see:
MEDIA MENU
supply core OD: (3.10" - 4.00")
Use the +/- buttons to enter the correct core diameter. The value is increased or
decreased in .01-inch increments. If you do not know the diameter, use a ruler and
measure the outside diameter of the core, and enter the value in this submenu.
5. Press ACCEPT. You then see:
MEDIA MENU
4-pass servo target temperature: 150F
The temperature increments or decrements by 1 degree. The maximum
temperature setting is 155
setting.
6. Press ACCEPT. You then see:
MEDIA MENU
8-pass servo target temperature: 135F
The temperature increments or decrements by 1 degree. The maximum
temperature setting is 155
setting.
7. Press ACCEPT. You then see:
MEDIA MENU
conserve media: ON
Use the +/- buttons to turn media conservation ON/OFF. The default value is ON.
When set to ON, the printer rewinds the substrate to minimize waste before
printing the next image.
3-12
F. Use the +/- buttons to change the temperature
º
F. Use the +/- buttons to change the temperature
º