Table of Contents
Advertisement
4.
Press the LOAD MEDIA button. You then see:
Load Media
new supply roll?
5.
Press the MENU button. You then see:
Load Media
reattach takeup?
6.
Press the ACCEPT button. You then see:
Use +/- keys, attach
takeup, press ACCEPT
7.
Load an empty take-up core the same width as the supply media. Adjust the EMTU
hubs left to right as required to align the edges of the core with the edges of the media
coming out of the printer, and secure the hubs by tightening the knobs.
8.
Pull on both sides of the media evenly. A second person can press the + button to
advance the media until you are able to get it over the top of the empty take-up core.
Secure the media firmly with tape along the core in five places. Tape the leading edge
of the media to the core at the right side, the far left side, and in three more places
equally spaced at the middle (see Figure 3-19).
9.
Turn the take-up core with the taped media one revolution.
10.
Press ACCEPT. You then see:
Sizing media
please wait
The printer sizes the media. If an error occurs, check the alignments along the
media path from the supply to the take-up core.
If no error occurs, you then see:
MEDIA MENU
media delivery mode: roll to roll or Print & Go
Use the +/- buttons to select Print & Go.
11.
Press ACCEPT. You then see:
Stabilizing media
please wait
When stabilizing is complete, printer status information is displayed.
7/26/04
Print & Go Media Installation
3-27
Advertisement
Table of Contents
