Table of Contents
Advertisement
Océ | Media System
11.
Close the top cover and the front and rear doors, and press the ACCEPT button on
the control panel. You then see:
MEDIA MENU
print side: first side
If you select the first side, go to step 15.
12.
Use the +/- buttons to select the second side. You then see:
MEDIA MENU
print side: second side
13.
Press ACCEPT. You then see:
SECOND SIDE
Supply Core OD: (3.10" - 4.0")
Use the +/- buttons to enter the correct core diameter. The value is increased or
decreased in .01-inch increments. If you do not know the diameter, use a ruler and
measure the outside diameter of the core, and enter the value in this submenu.
14.
Press ACCEPT. You then see:
SECOND SIDE
condition media: OFF
Use the +/- buttons to turn media conditioning OFF/ON. The default value is
OFF.
Condition Media assists in accurate two-sided printing where the printed media
surface tension of the first side affects the printing of the second side. When set
ON, the printer advances the media the length of the print and rewinds to the
starting point.
For additional information, see "Firmware 2.2 Notes" on page C-12.
15.
Press ACCEPT. You then see:
MEDIA MENU
media name
Use the +/- buttons to select the media type you have loaded.
If you select the Other media option, see "Media Types: Other" on page 3-11.
16.
Press ACCEPT. You then see:
MEDIA MENU
Takeup Core OD: (3.10" - 4.0")
Use the +/- buttons to enter the correct core diameter. The value is increased or
decreased in .01-inch increments. If you do not know the diameter, use a ruler and
measure the outside diameter of the core, and enter the value in this submenu.
3-10
Advertisement
Table of Contents
