Table of Contents
Advertisement
Océ | Control Panel
Operator
0.4
The Operator menu provides access to the following submenus:
•
Print Parameters - Contains the horizontal and vertical margin values, job
statistics (On or Off), stripe (single or dual), quad strike (Off or On), minimal
maintenance during print (Off or On), and double print (Off or On) submenus
(see "Print Parameters Menu" on page A-3).
•
Test Prints - Contains the nozzle, configuration, color bars, and menu tree test
prints (see "Test Prints Menu" on page A-4).
•
Maintenance - Contains the access carriage, park carriage, high, low, long and
mini purge nozzles submenus. Also includes the spit heads, pump solvent, fill
reservoir, and barcode practice submenus (see "Maintenance Menu (Part 1)" on
page A-5).
•
Pre warm - Contains the pre warm-up time submenu (see "Maintenance Menu
(Part 2)" on page A-6).
•
Media Menu - Contains menus for supply media selection and setup (see
"Media Menu" on page A-8).
•
Ink Menu - Contains menus for ink installation (see "Ink Menu" on page A-9).
•
About Printer - Enables you to view the total media printed, firmware version,
firmware build date/time, printer serial number, and boot ROM version (see
"About Printer Menu" on page A-10).
•
Units - Select between English or metric units (see "Units Menu" on page A-
11).
•
Set Clock - Set up the printer date and time (see "Set Clock Menu" on page A-
12).
Print Parameters
0.4.1
The Print Parameters menu sets up the basics of the print job, the controls for the image
margins, and the statistics for the job.
Follow these steps to use the Print Parameters menus:
1.
Navigate to:
MAIN MENU
operator
2.
Press the ACCEPT button. You then see:
OPERATOR
print parameter
3.
Press MENU. You then see:
PRINT PARAMETERS
hor margins: (0.2" - 4.0")
4-6
Advertisement
Table of Contents
