Table of Contents
Advertisement
17.
Press ACCEPT. You then see:
MEDIA MENU
conserve media: ON
Use the +/- buttons to turn media conservation ON/OFF. The default value is ON.
When set to ON, the printer rewinds the substrate to minimize waste before
printing the next image.
When set to OFF, the printer does not rewind the substrate before printing. This
setting should be used for media that is very thin or adhesive backed, which may
wrinkle during rewinding or become malformed by the heat required to dry the
inks.
For additional information, see "Firmware 2.2 Notes" on page C-12.
18.
Press ACCEPT. You then see:
MEDIA MENU
feed adjustment: +/- 0 - 10
Use the +/- buttons to set the feed adjustment from -10 to +10. The default value
is 0.
This feature enables the adjustment of media stepping to compensate for variation
in media lots and environmental factors. The plus direction lengthens each media
step. The minus direction shortens each media step.
For additional information, see "Firmware 2.2 Notes" on page C-12.
19.
Press ACCEPT. You then see:
Sizing media
please wait
The printer sizes the media. If an error occurs, check the alignments along the
media path from the supply to the take-up core.
If no error occurs, you then see:
Stabilizing media
please wait
When stabilizing is complete, printer status information is displayed.
Media Types: Other
Selecting Other enables additional menus for manual media setup. When changing values,
holding the +/- buttons continuously increments or decrements the value repeatedly. Follow
the steps below for this media type option:
1.
You then see:
MEDIA MENU
Other
7/26/04
Roll-to-Roll Media Installation
3-11
Advertisement
Table of Contents
