Table of Contents
Advertisement
Océ | Printer Maintenance
Heater Filters
Two other drying filters are located on each end of the printer behind the lower cosmetic
plastic covers. Each filter should be exchanged for a new one when the filter fabric begins to
discolor from the original condition or once every two months. The drying system filter
replacement (Dim: 15 in. x 11 in. x 2 in.) is OIN #3011874189. These filters require tool
access (4-mm Allen wrench). Remove the capture bracket at the top of the heater box, then
replace the filter (see Figure 5-16).
Note: An airflow direction arrow is printed on the side of the filter. The arrow should
be pointing in toward the printer when installed because the air is being drawn
into the heater box.
Figure 5-16 Purolator Hi-40 Heater Filters
5-16
Advertisement
Table of Contents
