Pim-Sm Non-Scoped Zone Configuration Example - HP 6125G Configuration Manual

PIM-SM non-scoped zone configuration example

Network requirements
As shown in
different organizations form stub networks, and one or more receiver hosts exist in each stub network. The
entire PIM-SM domain contains only one BSR.
Host A and Host C are multicast receivers in two stub networks.
VLAN-interface 105 on Switch D and VLAN-interface 102 on Switch E act as C-BSRs and C-RPs. The
C-BSR on Switch E has a higher priority. The multicast group range served by the C-RP is 225.1.1.0/24.
Modify the hash mask length to map a certain number of consecutive group addresses within the range
to the two C-RPs.
IGMPv2 runs between Switch A and N1 and between Switch B/Switch C and N2.
Figure 47 Network diagram
Device
Switch A
Switch B
Switch C
Configuration procedure
Configure the IP address and subnet mask for each interface as per
1.
Figure 47, receivers receive VOD information through multicast. The receiver groups of
Interface IP address
Vlan-int100 10.110.1.1/24
Vlan-int101 192.168.1.1/24
Vlan-int102 192.168.9.1/24
Vlan-int200 10.110.2.1/24
Vlan-int103 192.168.2.1/24
Vlan-int200 10.110.2.2/24
Vlan-int104 192.168.3.1/24
Device Interface
Switch D Vlan-int300
Vlan-int101
Vlan-int105
Switch E Vlan-int104
Vlan-int103
Vlan-int102
Vlan-int105
139
IP address
10.110.5.1/24
192.168.1.2/24
192.168.4.2/24
192.168.3.2/24
192.168.2.2/24
192.168.9.2/24
192.168.4.1/24
Figure 47. (Details not shown.)