Pim-Sm Non-Scoped Zone Configuration Example - HP 6125XLG Configuration Manual

PIM-SM non-scoped zone configuration example

Network requirements
As shown in
subnets form stub networks, and at least one receiver host exist in each stub network. The entire PIM-SM
domain contains only one BSR.
Host A and Host C are multicast receivers in two stub networks N1 and N2.
Both VLAN-interface 105 on Switch D and VLAN-interface 102 on Switch E act as C-BSRs and C-RPs. The
C-BSR on Switch E has a higher priority. The C-RPs provide services for the multicast group range
225.1.1.0/24. Modify the hash mask length to map the multicast group range to the two C-RPs.
IGMPv2 runs between Switch A and N1, and between Switch B, Switch C, and N2.
Figure 33 Network diagram
Source
10.110.5.100/24
Table 7 shows the interface and IP address assignment, and network topology scheme.
Table 7 Interface and IP address assignment
Device
Switch A
Switch A
Switch A
Switch B
Switch B
Switch C
Figure 33, VOD streams are sent to receiver hosts in multicast. The receivers of different
Vlan-int300 Vlan-int105
Vlan-int105
Switch D
PIM-SM
Interface
VLAN-interface 100
VLAN-interface 101
VLAN-interface 102
VLAN-interface 200
VLAN-interface 103
VLAN-interface 200
Switch A
Vlan-int100
Vlan-int102
Vlan-int102
Vlan-int103
Vlan-int103
Vlan-int104
Switch E
Vlan-int104
Vlan-int200
Switch C
87
Receiver
Host A
Host B
Receiver
Vlan-int200
Switch B
Host C
Host D
IP address
10.110.1.1/24
192.168.1.1/24
192.168.9.1/24
10.110.2.1/24
192.168.2.1/24
10.110.2.2/24