Pim-Sm Non-Scoped Zone Configuration Example - HP FlexFabric 5950 series Configuration Manual

The output shows the following information:
•
Switches on the SPT path (Switch A and Switch D) have the correct (S, G) entries.
•
Switch A has the correct (*, G) entry.

PIM-SM non-scoped zone configuration example

Network requirements
As shown in
•
OSPF runs on the network.
•
VOD streams are sent to receiver hosts in multicast. The receivers of different subnets form
stub networks, and a minimum of one receiver host exist on each stub network.
•
The entire PIM-SM domain contains only one BSR.
•
Host A and Host C are multicast receivers on two stub networks N1 and N2.
•
Specify VLAN-interface 102 on Switch E as a C-BSR and a C-RP. The C-RP is designated to
multicast group range 225.1.1.0/24. Specify VLAN-interface 101 of Switch D as the static RP on
all the switches to back up the dynamic RP.
•
IGMPv2 runs between Switch A and N1, and between Switch B, Switch C, and N2.
Figure 56 Network diagram
Source
10.110.5.100/24
Table 10 Interface and IP address assignment
Device
Switch A
Switch A
Switch A
Figure 56:
Vlan-int300 Vlan-int105
Vlan-int105
Switch D Switch E
PIM-SM
Interface IP address
Vlan-int100 10.110.1.1/24
Vlan-int101 192.168.1.1/24
Vlan-int102 192.168.9.1/24
Switch A
Vlan-int100
Vlan-int102
Vlan-int102
Vlan-int103
Vlan-int103
Vlan-int104
Switch B
Vlan-int104
Vlan-int200
Switch C
Device
Switch D
Switch D
Switch D
154
Receiver
Host A
Host B
Receiver
Vlan-int200
Host C
Host D
Interface IP address
Vlan-int300 10.110.5.1/24
Vlan-int101 192.168.1.2/24
Vlan-int105 192.168.4.2/24