Periodic Maintenance - Oce CS6407 Quick Reference Manual

Periodic maintenance

< Checking the wiper blade for contamination>
Visually check the wiper blade for contamination and
scratches.
If the wiper blade is scratched, replace it.
1
Open the front cover, and then open the wipe
cover.
2
Visually check the wiper blade for
contamination and scratches.
Wiper blade
Note
- Check the level of the remaining wiper cleaning liquid. If
small amount of wiper cleaning liquid is remaining, replenish
it.
3
Close the wipe cover and the front cover.
<Replenishing wiper cleaning liquid>
When the remaining wiper cleaning liquid becomes little,
replenish it.
1
Open the front cover, and then open the wipe
cover.
2
Visually check the wiper cleaning liquid level
through the cleaning liquid port at the lower
right of the top face of the wipe unit.
Cleaning liquid port
24
Wiper blade
Liquid level
If the liquid lever is below the top of the " " mark that
can be seen inside the cleaning liquid port, replenish
wiper cleaning liquid to a level below the top of the
" " mark.
Wiper cleaning liquid
3
Close the wipe cover and the front cover.
<Cleaning the capping unit>
1
Attach the cleaning roller to the cleaning stick.
2
1
2
Set the printer to the offl ine state and press the
key to display PH.MAIN MENU.
M E N U
I N K M E D I A R E G
M E D I A M . A D V
3
Press the key to enter PH.MAIN MENU. The
cap cleaning menu is displayed.
# C A P C L E A N I N G
>
4
Press the key. When the confi rmation screen
appears, press the
The carriage moves.
# C A P C L E A N I N G
>
# C A P C L E A N I N G
* O K ?
C A R R I A G E M O V I N G
P L E A S E W A I T
- When the carriage moves, the warning beeps.
key again.