Configure ONYX Software for White Ink / Varnish
Configure ONYX Software for White Ink / Varnish
Introduction
This section describes how to configure ONYX software (either THRIVE or ProductionHouse) to
recognize white ink or varnish workflow elements and thus allow you to apply the approach that
is best for your print job application. In order for the ONYX software to successfully address
white ink or varnish workflow data, there are options in the software that must be configured. It
also explains how you need to use specific ONYX media profiles to prepare white ink and varnish
print jobs.
NOTE
Step 1 and 2 below are required for ProductionHouse only. Step 3 is needed for both
ProductionHouse and THRIVE.
Procedure
1.
Within Rip-Queue, access the Configure Rip Options Palette.
[82] Set up ONYX RIP
2.
Once here, ensure that Overprint is turned on (checked).
3.
In your Quick Set, or in Preflight/Job Properties/Postscript turn off two-stage processing (make
sure the box is not checked).
126
Chapter 9 - How to Work With White Ink and Varnish
Océ Arizona 600 Series