Configure The Network Settings Of The Océ Tcs500 - Oce TCS500 User Manual

Configure the network settings of the Océ TCS500
Configure the network settings of the Océ TCS500
Introduction
The system administrator is responsible for installing and configuring the Océ
TCS500 in the network environment. There are two ways to configure the network
settings.
From the printer operator panel
The off-line screen on the printer operator panel contains a wizard to configure
the network settings.
With the System Administrator settings in the Océ Settings Editor.
The Océ Settings Editor allows you to configure a large number of system
settings. Only the system administrator is authorised to define the system
settings.
Actions in the Configure system wizard
You can perform the following actions in the 'Configure system' wizard.
Enable DHCP
Set the IP address
Set the IP subnet mask
Set the default gateway
Configure the DNS settings
Configure the primary and secondary WINS
Clear the set memory.
Use this option for a damaged job that you cannot delete in the Océ Queue
Manager.
The 'Configure system' wizard also contains installation settings and service
settings. A password protects the installation settings and the service settings. Only
Océ service engineers can access the installation settings and the service settings.
How to configure the system from the printer operator panel
Press the on-line / off-line key to set the printer off-line
1.
(see 'The on-line mode and the off-line mode' on page
Use the upper softkeys to scroll to the 'Configure system' card.
2.
66 Chapter 3 Prepare the Océ TCS500 for use
(see 'Clear the set memory' on page 268).
36).