To Recall Reference Waveform Files From A Usb Storage Device; To Recall Arbitrary Waveforms - Agilent Technologies InfiniiVision 3000 X-Series User Manual

2 Press the softkey in the second position and use the Entry knob to
3 Press the Press to Recall softkey.
4 If you would like to clear the display or clear the recalled mask, press

To recall reference waveform files from a USB storage device

1 Press the [Save/Recall] key.
2 In the Save/Recall Menu, press the Recall softkey.
3 In the Recall Menu, press the Recall softkey and turn the Entry knob to
4 Press the To Ref: softkey and turn the Entry knob to select the desired
5 Press the softkey in the second position and use the Entry knob to
6 Press the Press to Recall softkey.
7 If you would like to clear the display of everything except the reference

To recall arbitrary waveforms

Arbitrary waveform files can be recalled from one of four internal (\
Agilent Flash) locations or from an external USB storage device.
When recalling arbitrary waveforms (from an external USB storage device)
that were not saved from the oscilloscope, be aware that:
• If the file contains two columns, the second column is automatically
• If the file contains more than two columns, you are prompted to select
Agilent InfiniiVision 3000 X-Series Oscilloscopes User's Guide
navigate to the file to recall. See
page 282.
A message indicating whether the recall was successful is displayed.
Clear Display or Clear Mask.
select Reference Waveform data (*.h5) .
reference waveform location.
navigate to the file to recall. See
page 282.
A message indicating whether the recall was successful is displayed.
waveform, press Clear Display.
chosen.
which column to load. Up to five columns are parsed by the
oscilloscope; columns above the fifth are ignored.
Save/Recall (Setups, Screens, Data)
"To navigate storage locations"
"To navigate storage locations"
18
on
on
285