Lin Serial Decode - Agilent Technologies InfiniiVision 3000 X-Series User Manual

LIN Serial Decode

To set up the oscilloscope to capture LIN signals, see
Signals"
For LIN triggering setup see
N O T E
To set up LIN serial decode:
1 Press [Serial] to display the Serial Decode Menu.
2 Choose whether to include the parity bits in the identifier field.
3 If the decode line does not appear on the display, press the [Serial] key
4 If the oscilloscope is stopped, press the [Run/Stop] key to acquire and
If the setup does not produce a stable trigger, the LIN signal may be slow enough that the
N O T E
oscilloscope is AutoTriggering. Press the [Mode/Coupling] key, then press the Mode
softkey to set the trigger mode from Auto to Normal.
You can use the horizontal Zoom window for easier navigation of the
decoded data.
See Also
•
•
•
Agilent InfiniiVision 3000 X-Series Oscilloscopes User's Guide
on page 359.
a If you want to mask the upper two parity bits, ensure that the box
under the Show Parity softkey is not selected.
b If you want to include the parity bits in the identifier field, ensure
that the box under the Show Parity softkey is selected.
to turn it on.
decode data.
"Interpreting LIN Decode"
"Interpreting LIN Lister Data"
"Searching for LIN Data in the Lister"
CAN/LIN Triggering and Serial Decode
"LIN Triggering" on page 361.
on page 364
on page 365
on page 366
23
"Setup for LIN
363