Arinc 429 Serial Decode - Agilent Technologies InfiniiVision 3000 X-Series User Manual

6 If you select the Label Range condition, use the Lable Min and Label Max
You can use the Zoom mode for easier navigation of the decoded data.
To display ARINC 429 serial decode, see
N O T E

ARINC 429 Serial Decode

To set up the oscilloscope to capture ARINC 429 signals, see
ARINC 429 Signals"
For ARINC 429 triggering set up see
N O T E
To set up ARINC 429 serial decode:
1 Press [Serial] to display the Serial Decode Menu.
2 In the submenu accessed by the Settings softkey, you can use the Base
Agilent InfiniiVision 3000 X-Series Oscilloscopes User's Guide
Use the Define softkey to select SDI, Data, or SSM. The SDI or SSM
selections may not be available, depending on word format selection in
the Serial Decode Menu.
Use the Bit softkey to select the bit to change.
Use the 0 1 X softkey to set the bit value.
Use the Set all Bits softkey to set all bit values to 0, 1, or X.
softkeys to specify the ends of the range.
Again, label values are always displayed in octal.
on page 414.
softkey to select between hexadecimal and binary display of the
decoded data.
MIL-STD-1553/ARINC 429 Triggering and Serial Decode
"ARINC 429 Serial Decode"
"ARINC 429 Triggering"
on page 417.
"Setup for
on page 415.
27
417