Peak-Peak; Maximum; Minimum; Amplitude - Agilent Technologies InfiniiVision 3000 X-Series User Manual

14
Measurements
•
•
•
•
•
•
•
•
•
•
•

Peak-Peak

The peak- to- peak value is the difference between Maximum and Minimum
values. The Y cursors show the values being measured.

Maximum

Maximum is the highest value in the waveform display. The Y cursor
shows the value being measured.

Minimum

Minimum is the lowest value in the waveform display. The Y cursor shows
the value being measured.

Amplitude

The Amplitude of a waveform is the difference between its Top and Base
values. The Y cursors show the values being measured.

Top

The Top of a waveform is the mode (most common value) of the upper
part of the waveform, or if the mode is not well defined, the top is the
same as Maximum. The Y cursor shows the value being measured.
222
"Maximum" on page 222
"Minimum" on page 222
"Amplitude" on page 222
"Top" on page 222
"Base" on page 223
"Overshoot" on page 224
"Preshoot" on page 225
"Average" on page 225
"DC RMS" on page 226
"AC RMS" on page 226
"Ratio" on page 228
Agilent InfiniiVision 3000 X-Series Oscilloscopes User's Guide