Utility Settings; Setting Up The Oscilloscope's Lan Connection - Agilent Technologies InfiniiVision 3000 X-Series User Manual

20

Utility Settings

3 In the I/O Menu, press Configure.
When an I/O interface is installed, remote control over that interface is
always enabled. Also, the oscilloscope can be controlled via multiple I/O
interfaces (for example, USB and LAN) at the same time.
See Also
•
•
• The oscilloscope's Programmer's Guide.
•

Setting up the Oscilloscope's LAN Connection

When the DSOXLAN LAN/VGA module is installed, you can place the
oscilloscope on the network and set up its LAN connection. Once that is
done, you can use the oscilloscope's web interface or remotely control the
oscilloscope via the LAN interface.
The oscilloscope supports methods for automated LAN configuration or
manual LAN configuration (see
page 297). It is also possible to set up a point- to- point LAN connection
between a PC and the oscilloscope (see
Connection to a PC"
Once the oscilloscope is set up on the network, you can use the
oscilloscope's web page to view or change its network configuration and
access additional settings (like the network password). See
"Web Interface," starting on page 315.
296
• LAN — When a DSOXLAN LAN/VGA module is installed, you can use
the LAN Settings and LAN Reset softkeys to configure the LAN
interface. See "Setting up the Oscilloscope's LAN Connection"
page 296.
GPIB — When a DSOXGPIB GPIB module is installed, you can use the
•
Address softkey to configure the GPIB address.
• There are no configuration settings for the USB interface.
Chapter 21, "Web Interface," starting on page 315 (when the
oscilloscope is connected to a LAN).
"Remote Programming via the Web Interface"
"Remote Programming with Agilent IO Libraries"
on page 298).
"To establish a LAN connection"
"Stand- alone (Point- to- Point)
Agilent InfiniiVision 3000 X-Series Oscilloscopes User's Guide
on
on page 321
on page 322
on
Chapter 21,