To Output The Waveform Generator Sync Pulse; To Specify The Expected Output Load - Agilent Technologies InfiniiVision 3000 X-Series User Manual

When you create a new arbitrary waveform, the existing arbitrary waveform definition
C A U T I O N
is overwritten. Note that you can use the [Save/Recall] key and menu to save
arbitrary waveforms to one of four internal storage locations or to a USB storage
device, and you can recall them later. See
and
If the source waveform frequency and/or voltage exceed the capabilities of the waveform
N O T E
generator, the arbitrary waveform will be limited to the capabilities of the waveform
generator. For example, a 20 MHz waveform captured as the arbitrary waveform, becomes a
12 MHz waveform.

To output the waveform generator sync pulse

1 If the Waveform Generator Menu is not currently displayed on the
2 In the Waveform Generator Menu, press the Settings softkey.
3 In the Waveform Generator Settings Menu, press the Trig Out softkey and
Waveform Type
All waveforms except
DC, Noise, and
Cardiac
DC, Noise, and
Cardiac

To specify the expected output load

1 If the Waveform Generator Menu is not currently displayed on the
Agilent InfiniiVision 3000 X-Series Oscilloscopes User's Guide
"To recall arbitrary waveforms"
The source waveform is decimated into 8192 (maximum) or fewer
arbitrary waveform points.
oscilloscope's softkeys, press the [Wave Gen] key.
turn the Entry knob to select Waveform Generator Sync Pulse.
Sync Signal Characteristics
The Sync signal is a TTL positive pulse that occurs when the waveform
rises above zero volts (or the DC offset value).
N/A
oscilloscope's softkeys, press the [Wave Gen] key.
"To save arbitrary waveforms"
on page 285.
Waveform Generator
on page 282
17
267