18
Save/Recall (Setups, Screens, Data)
• The oscilloscope uses a maximum of 8192 points for an arbitrary
To recall an arbitrary waveform:
1 Press [Save/Recall] > Recall > Recall:; then, turn the Entry knob to select
2 Press the softkey in the second position and use the Entry knob to
3 Press the Press to Recall softkey.
4 If you would like to clear the display, press Clear Display.
See Also
•
Recalling Default Setups
1 Press the [Save/Recall] key.
2 In the Save/Recall Menu, press Default/Erase.
3 In the Default Menu, press one of these softkeys:
Performing a Secure Erase
1 Press the [Save/Recall] key.
2 In the Save/Recall Menu, press Default/Erase.
286
waveform. For more efficient recalls, make sure your arbitrary
waveforms are 8192 points or less.
Arbitrary Waveform data (*.csv).
navigate to the file to recall. See
page 282.
A message indicating whether the recall was successful is displayed.
"To edit arbitrary waveforms"
Default Setup— recalls the oscilloscope's default setup. This is the same
•
as pressing the front panel [Default Setup] key. See
Oscilloscope Setup"
Some user settings are not changed when recalling the default setup.
Factory Default— recalls the oscilloscope's factory default settings.
•
You must confirm the recall because there are no user settings that
are left unchanged.
"To navigate storage locations"
on page 263
on page 31.
Agilent InfiniiVision 3000 X-Series Oscilloscopes User's Guide
on
"Recall the Default