File Explorer - Agilent Technologies InfiniiVision 3000 X-Series User Manual

Now, the instrument is connected, and the instrument's web interface or
remote control via LAN may be used.

File Explorer

The File Explorer lets you navigate the oscilloscope's internal file system
and the file systems of connected USB storage devices.
From the internal file system, you can load oscilloscope setup files or
mask files.
From a connected USB storage device, you can load setup files, mask files,
license files, firmware update (*.cab) files, label files, etc. Also, you can
delete files on a connected USB storage device.
The USB port on the front panel, and the USB port on the rear panel labeled "HOST" are
N O T E
USB Series A receptacles. These are the receptacles to which you can connect USB mass
storage devices and printers.
The square receptacle on the rear panel labeled "DEVICE" is provided for controlling the
oscilloscope over USB. See the Programmer's Guide for more information.
The oscilloscope's internal file system, under "\Agilent Flash", consists of
10 locations for oscilloscope setup files, and four locations for mask files.
To use the File Explorer:
1 Press [Utility] > File Explorer.
2 In the File Explorer Menu, press the softkey in the first position and
Agilent InfiniiVision 3000 X-Series Oscilloscopes User's Guide
This may take a few minutes.
use the Entry knob to navigate.
20
Utility Settings
299