Agilent Technologies InfiniiVision 3000 X-Series User Manual page 219

Measurement
"Phase"
"Preshoot"
"Ratio"
"Rise Time"
"DC RMS"
"AC RMS"
"Top"
"+ Width"
"– Width"
"X at Max Y"
"X at Min Y"
*
Power App
Note that additional Power App measurements are available when the
Measurements
DSOX3PWR power measurement and analysis license is installed and the
Power Application is enabled. For more information, see the DSOX3PWR
Power Measurement Application User's Guide at
"www.agilent.com/find/3000X- Series- manual"
Dual-Channel
Note that additional measurements are available with the N2820A
(N2820A Probe)
high- sensitivity current probe when both the Primary and Secondary
Measurements
probe cables are used. Zoom In waveform data below the probe's clamp
level is joined with Zoom Out waveform data above the probe's clamp level
to create the waveform on which the measurement is made. These
measurements are only valid for analog input channels.
Agilent InfiniiVision 3000 X-Series Oscilloscopes User's Guide
on page 233
on page 225
on page 228
on page 232
on page 226
on page 226
on page 222
on page 231
on page 231
on page 235
on page 234
Use the cursors to make other measurements on FFT.
Valid Valid for
for Digital
Math Channels
*
FFT
Yes
Yes
Yes
Yes
Measurements
Notes
Measures between two sources.
Press Settings to specify the
second source.
Measures between two sources.
Press Settings to specify the
second source.
The resultant units are in Hertz.
The resultant units are in Hertz.
or on the Documentation CD.
14
219