Passive Probes; Single-Ended Active Probes - Agilent Technologies InfiniiVision 3000 X-Series User Manual

Passive Probes

All InfiniiVision oscilloscopes recognize passive probes such as the
N2862A/B, N2863A/B, N2889A, N2890A, 10073C, 10074C, and 1165A.
These probes have a pin on their connector that connects to the ring
around the oscilloscope's BNC connector. Therefore, the oscilloscope will
automatically set the attenuation factor for recognized Agilent passive
probes.
Passive probes that do not have a pin that connects to the ring around
the BNC connector will not be recognized by the oscilloscope, and you
must set the probe attenuation factor manually. See
attenuation"
The following passive probes can be used with the InfiniiVision
3000 X- Series oscilloscopes. Any combination of passive probes can be
used.
Table 5
Model
1165A
10070C/D
10073C
10074C
10076A/B
N2771A/B
N2862A/B
N2863A/B
N2889A
N2890A

Single-Ended Active Probes

The following single- ended active probes can be used with the
InfiniiVision 3000 X- Series oscilloscopes.
Agilent InfiniiVision 3000 X-Series Oscilloscopes User's Guide
on page 69.
Passive Probes
Description
Passive probe, 10:1, 600 MHz, 1.5 m
Passive probe, 1:1 20 MHz, 1.5 m
Passive probe, 10:1, 500 MHz, 1.5 m
Passive probe, 10:1, 150 MHz, 1.5 m
Passive probe, 100:1, 4 kV, 250 MHz
Passive probe, 1000:1, 30 kV, 50 MHz
Passive probe, 10:1, 150 MHz, 1.2 m
Passive probe, 10:1, 300 MHz, 1.2 m
Passive probe, 10:1/1:1, 350 MHz, 1.2 m
Passive probe, 10:1, 500 MHz, 1.2 m
Reference
"To specify the probe
335
22