Installing A Front Door And Air Intake Assemblies - Cisco Nexus 7000 Hardware Installation And Reference Manual

Replacing the Front Door and Air Intake Assemblies on the Cisco Nexus 7018 Chassis
1
2
3
4
5
To replace the front door and air intake assemblies, see the
Assemblies" section on page

Installing a Front Door and Air Intake Assemblies

When you install a front door and air intake assembly components, you install hardware to hold the door
and air intake assemblies, attach the door, and then attach the air intake assembly.
To install the front door and air intake assembly components, follow these steps:
Open the Front Door and Air Intake kit (69-1962-01) and verify that it includes the following
Step 1
components:
•
•
•
•
•
•
•
•
Position the left door stopper (has an L on its base) on the middle of the left side of the cable management
Step 2
frame and fasten it with two M3x14 pan-head screws as shown in
to 8.4 to 11 in-lb (0.9 to 1.2 N·m).
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
10-90
Box for the kit
Front door box
Air intake frame box
Bottom hinge bracket box
Filler boxes
10-90.
1 front door (800-31268-01)
1 air intake frame (800-31270-01)
1 bottom hinge bracket (700-28491-02)
1 left door stopper (has an L on its base) (700-27454-01)
1 right door stopper (has an R on its base) (700-27592-01)
8 M4x8 pan head screws (48-0398-01)
4 M3x14 pan head screws (48-1699-01)
4 ball-point studs (51-5171-01)
Chapter 10 Installing or Replacing Components
6 Small parts bag placed in a filler box
7
Fold the short flaps on top.
8 Fold the long flaps on top of the short flaps.
9 Tape the long flaps to the box.
"Installing a Front Door and Air Intake
Figure 10-43. Tighten these two screws
OL-23069-07