Cisco Nexus 7000 Hardware Installation And Reference Manual page 482

Repacking the System Components
1 Open the box.
2
Insert the front door box into
the main box.
3
Insert the air intake frame
box next to the front door box
and at the bottom of the main
box.
4 Place the bottom hinge
bracket box on top of the air
intake frame box.
5 Place two filler boxes on top
of the bottom hinge bracket
box.
Remove and repack the cable management system by following these steps:
Step 10
Loosen and remove the eight M4x8 pan-head screws that fasten the top cover to the upper cable
a.
management assemblies and chassis (see
Figure E-28
1 Four M4x8 pan-head screws fastened to the
chassis
b. Remove the top cover from the chassis and the two upper cable management assemblies.
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
E-44
Appendix E
6 Place the bag of small parts bag in one of the filler boxes
7
Fold the two short flaps over the top of the box.
8
Fold the two long flaps over the top of the short flaps.
9 Tape the tow long flaps together and to the box with packing
tape.
Detaching the Top Cover from the Upper-Cable-Management Assemblies and Chassis
Repacking the Cisco Nexus 7000 Series Switch for Shipment
Figure E-28).
2 Four M4x8 pan-head screws fastened to the
two upper cable management assemblies
OL-23069-07