Cisco Nexus 7000 Hardware Installation And Reference Manual page 139

Chapter 5 Installing a Cisco Nexus 7018 Chassis
To install the cable management assemblies on the Cisco Nexus 7018 switch chassis, follow these steps:
Attach a lower cable management assembly (800-31343-01) onto the two hooks that protrude from the
Step 1
lower half of the left rack-mount bracket that is attached to the Cisco Nexus 7018 switch chassis, and
loosely fasten the assembly to the chassis with four flat-head M4x10 screws as shown in
Figure 5-8
1 Lower cable management assembly. 3
2 Rack-mount bracket.
Repeat Step 1 to attach a lower cable management assembly to the right side of the chassis.
Step 2
OL-23069-07
Attaching a Lower Cable Management Assembly to a Rack-Mount Bracket
4
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
Installing the Cable Management Frame
Position the assembly so that the two lower hooks on
the rack-mount bracket fit inside the two holes on the
assembly, and then slide the assembly down so that it is
held by the hooks.
Loosely fasten the assembly to the rack-mount bracket
with four M4x10 screws. Do not tighten these screws.
Figure 5-8.
5-17