Cisco Nexus 7000 Hardware Installation And Reference Manual page 457

Appendix E Repacking the Cisco Nexus 7000 Series Switch for Shipment
Figure E-12
1 Cable management frame
2 Front-mount bracket
c. Remove the other cable management frame by repeating Step 7b.
Step 9 Disconnect the ground cable from the chassis by loosening and removing its two M4 screws. Place the
screws in a small parts bag for the accessory kit. For a location of the grounding pad, see
page 3-22.
Remove the chassis from the rack by following these steps:
Step 10
Unscrew 12 screws holding the chassis to each side of the rack (6 screws on each side). Place the
a.
screws in the small parts bag for the accessory kit.
Do not remove the six screws used to hold the two bottom support brackets to the rack. They are required
Caution
to hold the chassis in place until you remove it from the rack.
OL-23069-07
Removing a Side Cable Management Frame
3 Frame removed by pulling up and then away from the chassis
4 Six M4 screws to be removed.
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
Repacking the System Components
Figure 3-12 on
E-19