Installing Storage Media in a Supervisor Module
Figure 3-26
For a Supervisor 2 or 2E module, insert the USB drive in the LOG FLASH or SLOT0 port.
•
Wait for the reader or port LED to turn green and for a message to appear on the console as follows:
Step 2
If you are installing a card or USB drive into the log flash reader, the message will end with
•
"logflash:online."
If you are installing a card or USB drive into the expansion flash reader, the message will end with
•
"slot0:online."
If you see an "offline" message or do not see a message, either the card or USB drive is not fully
•
inserted or it is improperly formatted.
Make sure that the card or USB drive is fully inserted inside the reader. If it is fully inserted, either
format the card (see the Cisco Nexus 7000 Series NX-OS Fundamentals Configuration Guide) or
replace the storage media with another that is properly formatted for the reader.
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
3-36
Aligning a CompactFlash Card to its Reader
Chapter 3
Installing a Cisco Nexus 7009 Chassis
OL-23069-07