Cisco Nexus 7000 Hardware Installation And Reference Manual page 442

Repacking the System Components
If there is a front door on the chassis, remove and repack it as follows:
Step 4
Set the packing materials for the front door by the chassis.
a.
Holding the door on both sides, pull it away from the front of the chassis.
b.
Center the door (front side down as shown in Callout 2 in
c.
flattened inner box.
Figure E-1
4
1
1 Flattened inner box for the front door
2 Front door (front side down)
3 Smaller flaps (2) folded over the door
4
Larger flaps (2) folded over the door
5
Larger flaps taped together and to the box
6 Outer box opened for inner box
Fold the two smaller inner box flaps over the door (see Callout 3 in
d.
e. Fold the two larger inner box flaps over the door (see Callout 4 in
f. Tape the larger inner box flaps together and to the box (see Callout 5 in
g. Open the outer box (see Callout 6 in
h. Place four corner pads in the inner lower corners of the outer box (see Callout 7 in
Place the inner box inside the outer box and on the corner pads (see Callout 8 in
i.
Place four corner pads on the upper corners of the inner box (see Callout 9 in
j.
Fold the smaller flaps over the inner box (see Callout 10 in
k.
Fold the two larger flaps over the inner box (see Callout 11 in
l.
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
E-4
Packing the Front Door for the Cisco Nexus 7004 Chassis
2
3
3
4
Appendix E Repacking the Cisco Nexus 7000 Series Switch for Shipment
Figure
9
5
9
9
8
7
7
11
10
6
7 Corner pads placed in each corner
8 Inner box placed in outer box and on corner
pads
9 Corner pads placed on each inner box corner
10 Smaller flaps (2) folded over inner box
11 Larger flaps (2) folded over inner box
12 Larger flaps taped together and to box
Figure E-1).
Figure
E-1) on center section of the
9
7
7
12
10
11
Figure E-1).
Figure E-1).
Figure E-1).
Figure
Figure E-1).
Figure E-1).
E-1).
Figure E-1).
OL-23069-07
E-1).