Cisco Nexus 7000 Hardware Installation And Reference Manual page 91

Chapter 3 Installing a Cisco Nexus 7009 Chassis
Figure 3-19
1
Assemble the right and left sides of the right door stop
around the cable management post. Be sure that each
bushing sticks out above or below the assembled door
stop.
Position the hinge bracket at the bottom of the two cable management side frames and align two
Step 4
alignment pins on the hinge bracket (part number 700-31339-01) to two alignment holes in the chassis
as shown in
screw holes in each of the cable management side frames should align to screw holes in the hinge
bracket.
OL-23069-07
Assembling the Right Door Stop
Figure 3-20. Push the hinge bracket to the chassis so that the pins go into the chassis. Two
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
Installing the Front Door and Air Intake Frame
2
Use two M4 flat head screws to fasten
the two door stop pieces together.
3-29