Installing A Nam Module - Cisco Nexus 7000 Hardware Installation And Reference Manual

Installing a NAM Module

1
2
3
4
5
Step 11 On the replacement I/O module, rotate both ejector levers fully away from the front of the module.
If you are inserting the module into a Cisco Nexus 7010 chassis, rotate the module 90 degrees clockwise.
Step 12
Align the module to the chassis guides for the vacated slot, and slide the module part way into the slot.
Step 13
With one or both hands on the front of the module, push the module all the way into the slot until it seats
Step 14
on the midplane connector.
Simultaneously push both ejector levers inward until they come in contact with the face of the module.
Step 15
Verify that the ejector levers are fully closed before tightening the captive screws. Failure to fully seat
Note
the module in the backplane connector can result in error messages.
Step 16 Tighten the two captive screws on the I/O module to 8 in-lb (0.9 N·m).
Reconnect the I/O cables to the ports or the transceivers on the fiber-optic cables to the ports on the
Step 17
module.
Installing a NAM Module
The Network Analysis Module (NAM) can be installed in an I/O module slot on the Cisco Nexus 7004,
7009, 7010, or 7018 switch chassis. You can either replace a NAM or install a new one in an empty I/O
module slot. If you install a new module, you must also install and configure the latest NAM software
on the module.
Note If the switch shipped with one or more NAM modules already installed, then the modules are already
configured with the Prime NAM software and are ready to be used. If you are installing a new NAM
module and the module does not automatically boot up, then you must install and configure the Prime
NAM software in order to use the module.
This section describes how to install NAM modules and includes the following topics:
•
•
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
10-40
Put the I/O module in an ESD bag (not shown)
and then place it between the raised portions
of the flattened box.
Fold the shorter flaps along the front and back
of the module and then fold them over the
module.
Fold the longer flaps along the sides of the
module and then over the top of the module.
Tape the longer flaps together and to the box. 9
Insert each of the two sides of the box into one
of the foam blocks.
Required Tools for Installing a NAM, page 10-41
Installing or Replacing a NAM, page 10-41
Chapter 10 Installing or Replacing Components
6 Place the box and foam blocks into the larger
box.
7 Fold the narrow flaps over the box.
8 Fold the wide flaps over the box.
Tape the wide flaps together and to the box.
OL-23069-07